Manual
91
WPS-100-DVR-8CH Installation and Users Manual
© 2012 Wirepath Surveillance
Thefollowingisabriefdescriptionforeachiteminthismenuanditsspecicoperations:
•CAMERA
Selectthecameratodenemotiontriggeredevents.
•DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once
motion is detected for this camera. The buzzer and Alarm Out relay will reset immediately once motion
is no longer detected.
•CAMERATOGO
The Camera to GosettingwillspecifywhichPTZcamerawillgotoapredenedpresetwhenmotionis
detected for this camera. This feature is used in a system that includes PTZ cameras since the Camera
to Go must be a PTZ camera.
•GOTOPRESET
ThisfeatureworksinconjunctionwiththeCameratogosettingaboveanddenesthepresetpositionthe
Camera to Go PTZ camera will go to when motion is detected for this camera. For more details about
preset positions for PTZ cameras, please refer to Section 7.
•PRE-RECORD
DenehowmuchtimetheDVRwillrecordbeforemotionisdetected.ThePreRecordFPSsetinSection
9.3.5 determines the frame rate of this recording.
Note: Actual pre-record time may be shorter than the value set if the total size of the pre-record video
exceeds the pre-record video buffer.
•POST-RECORD
DenehowmuchtimetheDVRwillrecordaftermotionisdetected.ThePostRecordFPSsetinSection
9.3.5 determines the frame rate of this recording.
•ALARMOUT
DenewhichAlarmOutputwillbetriggeredwhenmotionforthiscameraisdetected.SelectN/A for
none or either of the Alarm Outputs (1 for NC or 2 for NO).
•BUZZER
By default the internal buzzer is disabled to sound when motion for this camera is detected.
•LOG
By default, the DVR will log to the Event Log when motion is detected.
•E-MAIL
Sendanemailmessagetopredenedemailaddressintheeventmotiondetectedforthiscamera.
See Section 9.3.11 for more information on e-mail.
•FTP
This DVR can send the recorded motion detection event for this camera to an FTP server.
•SCREENMESSAGE
By default, the DVR will display a motion detection message in the System Status Bar (visible from the VGA
or BNC main monitor output only) when motion is detected for this camera.