Manual

94
WPS-100-DVR-8CH Installation and Users Manual
 •GOTOPRESET
  DenethepresetPTZpositiontheFocusCamerawillgotoifthealarminputistriggered(thefocus
camera must be a PTZ camera for this feature). For more details about preset positions for PTZ
cameras, refer to Section 7.
 •PRE-RECORD
  DenehowmuchtimetheDVRwillrecordbeforethealarminputistriggered.ThePreRecordFPSset
in Section 9.3.5 determines the frame rate of this recording
Note: Actual pre-record time may be shorter than the value set if the total size of the pre-record video
exceeds the pre-record video buffer.
 •POST-RECORD
  DenehowmuchtimetheDVRwillrecordafterthealarminputistriggered.ThePostRecordFPSsetin
Section 9.3.5 determines the frame rate of this recording.
 •ALARMOUT
  DenewhichAlarmOutputwillbetriggeredwhenthealarminputistriggered.
 •BUZZER
By default, the internal buzzer is enabled to sound when the alarm input is triggered.
 •LOG
By default, the DVR will log when the alarm input is triggered to the event Log.
 •SCREENMESSAGE
By default, the DVR will display a message in the System Status Bar (visible from the VGA or BNC main
monitor output) when the alarm input is triggered.
 •E-MAIL
  Sendanemailmessagetoapredenedemailaddressintheeventthealarminputistriggered.The
default setting is disabled. See Section 9.3.11 for more information on e-mail.
 •FTP
This DVR can send the recorded video from the associated camera when an alarm input is triggered.