User manual Mini Hawk III Revolution

ARF VERSION ONLY:

Shift the servo in the compartment so that

when the servo horn is in a neutral position the

aileron is also in a perfectly neutral position. In

order to ensure that the compartment cover

will t, the rod has to be perpendicular to the

aileron.

After adjusting the servo to the correct position,

x it in place with a mounting clamp. Then

using a cannula, pour liquid superglue between

the servo and wing. As an alternative

adhesive you can also use a good resin, howe-

ver the servo adjustment would happen

after the application of the resin.

ARF VERSION ONLY:

Seal the compartment cover with UHU POR

(contact adhesive!). That way the cover can

be easily removed later.

Screw the wings to the fuselage with the M4

screw included.

The last step is to mark the model’s center of gravity on the bottom of the wing according to the

table and then shift the ight battery to the center of gravity corresponding with these specications.

Provided that you comply with our center of gravity recommendation of 51mm, there is already a

laminated mark on the fuselage.