User manual Mini Hawk III Revolution

Install the propeller and spinner.

Even with the PNP version you should then

check that the spinner and propeller have been

securely fastened so that you can tighten the

screws if necessary.

Secure the battery and the regulator in the

fuselage with velcro strips. The receiver is to be

installed at the back of the fuselage (behind the

battery).

THE WING

The following description pertains to both ailerons,

however the picture illustrates only one side. Before

doing anything else, rst check if the fork-heads easily

pass through the Messing control horns in the aile-

rons. It is possible that the horns might need to be ex-

panded to 1.6mm using a drill. This also applies to

the pre-installed horns in the PNP version. Once

that is the case, screw the Messing control horns to

the ailerons using Loctite in order to keep the screws

xed in place.

ARF VERSION ONLY:

Remove both retaining plates on the aileron

servos with a milling cutter or a cable cutter.

Adjust the servos to a neutral position with a

servo tester.

ARF VERSION ONLY:

Apply shrink sleeves to both servos. Crop the

servo horn according to the picture and drill

the third hole from the inside to 1.6mm and then

screw it to the servo.

1,6 mm