User Manual

17 18
Operating
Quick low mode is now easier
than ever! When ipping,
there is no need to re-balance
because the sled is neutral.
Simply invert the sled
and rotate the monitor for
viewability.
NOTE: If you tilt the head,
make sure to set a new trim.
To reset the roll horizon to
default, LONG-press the trim
button on the control box for 6
seconds until both LEDs on the
control box turn off and pulse
back on.
Horizon is now reset.
Any previous TILT trim will be
maintained.
Should you wish to set the
ROLL trim, SHORT-press the
trim button on the control box
and position the sled to the new
level position while the LEDs
blink for 5 seconds.
When LED blinking stops,
your new horizon position (or
Dutch angle!) is now stored in
memory.
The dock offers the ability to
tilt the gimbal up to 30˚ while
remaining docked and secure.
To enable this feature, remove
the set screw from beneath the
stand mount with a 1/8” Allen
key.
Tilt angle is now secured with
the tilt lock knob pictured.
The included padded dock is
essential to protect the Volt’s
motors and electronics. Other
methods of docking may
damage the unit.
Always use the over-center
hook while docked.
TIP: You can remove
unnecessary docking rings and
gain precious gimbal height!
TIP: Instead of using the tilt
dock, you can also place the rig
on the balance stud and engage
the Volt motors.
Setting trim will hold the shot
with next to no operating
required!