User Manual

27 28
Add the included short rod
extensions to the nose box of
your M-1 top stage and tighten
with a at head screwdriver.
Slide on the control box and
secure with the threaded rod
caps. Tighten with a at head
screwdriver.
Other Tiffen rigs can utilize the
nose box adapter.
Remove the three Allen screws
from the top of your nose box,
slide the adapter onto the rig
and fasten with the included
Allen screws.
Snug down the assembly by
tightening the two set screws
on the bottom.
Installing the Control Box
The control box can be mounted to the nose of your sled with the
knobs facing either side, to accommodate regular or goofy operators.
Mounting to an integrated rod system, like on the M-1 nose, is easy. If
you’re using rod adapters or MDR plates on other rigs, make sure the
control box is afxed rigidly to the sled.
Installation Control Box
Ensure the power switch is in
the OFF position and connect
the short power cable from sled
power to the 12V IN port.
NOTE: If you use an
aftermarket power cable,
conrm the polarity is correct.
Volt is protected against reverse
voltage, but won’t work very
well without power.
REMEMBER: If your box is
mounted with the knobs to the
RIGHT (regular), you’ll align
the gimbal handle to the REAR
when powering on later.
However, if your box is mounted
with the knobs to the LEFT
(goofy), you’ll align the gimbal
handle to the FRONT when
powering on later.
See page 11 about power up.
Now let’s get to the gimbal!