User Manual

31 32
Installation
For M-1 gimbals, replace
BOTH covers with the supplied
threaded cap adapters using the
same pins on the blue whale
wrench.
Leave the trunnion screws in
place.
Next, if your gimbal is wearing
trunnion covers, remove BOTH
of them using the smallest pin
set on the blue whale wrench
supplied with your sled or
gimbal upgrade.
Slide the gimbal handle pulley
over the gimbal handle.
Line up the lock screws with the
four holes on the knurled blue
ring.
Use a 0.05” Allen key to tighten
the four lock screws enough to
secure the pulley. Do not over-
tighten.
TIP: If you’re upgrading a PRO
gimbal, it’s easier to install
the handle pulley during the
upgrade process.
For upgraded gimbals, install
one thread adapter ONLY on the
side of the gimbal where you
will mount the motor assembly.
Right side shown here. If
mounting Volt on the left,
thread the adapter to that side.
Leave the trunnion screws in
place.
M-1 gimbals use a 1/8” Allen
wrench to remove the small
button screw and Belleville
washer of the gimbal trunnion
from the PULLEY side.
We will be re-using the washer,
but set aside the screw.
Right side install shown.