User Manual

37 38
Pop out the little plastic plug
from the cover.
Use a non-metallic object to
carefully press and hold the
invert button for 3 seconds. All
LEDs will pulse off to indicate
the mode change.
Power off the unit and you’re
done ipping.
Installation
Important step for RIGHT mounted Volt
Left side mounting is default to the electronics within the Volt, so if
you mount the hockey stick on the right side, you must press the
ip button on the internal PC board. It’s just a button press, but pay
attention here.
If you mounted Volt on the LEFT side of the gimbal, skip this step!
Flip Button
Make sure the pause switch
is DOWN, indicating the Volt
motors will not run.
Switch the power ON and the
blue LEDs will illuminate.
Only press it once!
Each consecutive 3-second
press will toggle LEFT/RIGHT
side operation.
Replace the plastic cover.
NOTE: If you ip your Volt
to LEFT side mounting in the
future, you’ll have to repeat the
invert button process.
Plug in the 90˚ end of the
gimbal cable to the control box,
wrap a loop or two around the
post and plug in the Volt.
The LEMO connectors rotate
90˚ in the control box to allow
for convenient cable placement.