User Manual

41 42
The belts should not have any
slack, but not be so tight as to
create friction.
Slowly adjust, test and repeat.
TIP: You may wish to adjust
the tension again with Volt
powered on to check its
behavior.
The nishing touch is to spin
the trunnion weight into the
1/4-20” threads of the trunnion
pulley.
Just make sure it’s on tight,
no need to over-torque it.
Installation
Your Volt equipped sled should now be ready
for action! Flip back to page 7, and get ready to
balance before powering on.
Plug in the 90˚ end of the
gimbal cable to the control box,
wrap a loop or two around the
post and plug in the Volt.
The LEMO connectors rotate
90˚ in the control box to allow
for convenient cable placement.
TIP: Depending on your normal
builds, you may prefer the
optional “long” gimbal cable.
If you haven’t yet, reinstall the
gimbal onto the sled.
With the gimbal lock open, slide
the gimbal back onto the post
and re-assemble the top stage.
Motor belts