User Manual

STC-I550
www.stealthcam.net Toll Free 877-269-8490
25
• Open the front housing and move the switch to the ON position.
At this point, you have 30 seconds to make any program
adjustments.
• After 30 seconds the camera’s green LED light will begin
blinking and enter count down mode. This is your indication to
leave the coverage area within one minute.
• After one minute, the camera will enter either image burst
mode or adjustable video mode based on your program setting.
The camera will then time out between 1 ~ 59 minutes,
depending on your setting.
 The time between motion detection and the camera taking the
pictures may vary due to lighting conditions, charging of the
flash, program settings, and battery power level.
 The flash light will only activate in low light conditions.
 When the camera is set to AVI capturing, the camera cannot
use the flash feature. The quality of the video clip will turn out
well in good daytime lighting conditions. If the surrounding light
conditions are not enough, your unit will switch the AVI setting
to a single image capturing automatically.