Instructions / Assembly

- 18 -
Trouble shooting:
Trouble
Causes of Trouble
Trouble-Shooting Method
The machine does not start when power is
supplied
1. The fuse is burned.
2. The wire connection terminal is loose.
3. Bad Contact in the connection wire
between the controller and the steam
engine.
1. Change the fuse (on the shell
0.8A/250V)
2. Plug-in the wire connection terminal
3. Make sure the steam engine and
the controller is in good contact.
GFCI switch breaks automatically
1. The wire connector is damp or damaged.
2. The heating tube breaks
1. Check whether the wire connector
is damp or damaged, and dry with
dryer if dampened.
2. Change the heating tube.
When the machine is started, hot water comes
out with little or no steam
1. The water drainage valve is broken.
1. Change the water drainage valve.
The display screen on the control panel does not
display
1. The power wire is not connected properly.
The connection plug between the control
panel and the electrically-controlled box is
loose.
2. Trouble with plug board.
1. Tighten the loose connector, and
change the broken pipe.
2. Change the water input valve or the
water drainage valve.
Water leakage
1. The water pipe connector is loose or the
pipe breaks.
2. Water leakage in the water input valve or
the water drainage valve
1. Tighten the loose connector,
and change the broken pipe.
2. Change the water input valve
or the water drainage valve.
No steam when starting the machine
1. No electricity
2. No water
3. The set temperature is too low
4. Trouble with wire
1. Check the power supply
2. Check the water input pipe and
water input valve
3. Reset the temperature
4. Contact the distributor
The steam does not come out, there are water
sounds in the machine
1. The steam pipe is jammed.
1. Cut power supply to check whether
the steam pipe is smooth.
The light can not be turned on
1. The fuse is burned.
2. The light is broken.
3. The wire is broken.
4. The plug does not have good contact
1. Change the fuse (on the shell
1A/250V)
2. Change the light bulb.
3. Change wire.
4. Replace plug
The display box displays normally, but with no
steam input
1. Too much pressure inside the steam
engine, so the system breaks for heat
protection.
2. The heat protection wire is broken.
1. Check the team transport pipe and
restore automatically after heat
protection becomes cool.
2. Check the heat protection wire to
make sure the connection is good.