Instructions / Assembly

- 21 -
Controller Installation instruction
Attention: Before installing the controller, make sure the steam engine is shut off.
Step one
Determine the installation location of the controller.
For installation:
1. 4 -5feet away from the ground.
2. Locate controller on separate wall from steam nozzle.
3. Do not expose yourself to the direct spray of steam.
The controller wire is 1.5 feet long with a controller lengthened wire going to
the steam engine being 19.5 feet long. Installation of controller panel should be
in a position not more than 21 feet from the steam engine..
Attention: Do not install the controller under the water pipe or in a position
where water can easily make contact.
Step two
Drill a round hole of 35mm in diameter in a chosen position.
Step three
Pull the controller wire through the round hole, connect it to the corresponding wire in the
engine.
Attention: Do not over tighten or clip the controller wire.
Step four
Start the power supply of steam engine, check and adjust connection, check each item on the 6
th
page to make sure all functions work properly.
Attention: Before setting the controller,
make sure the steam engine is shut off.
Step five
Remove the paper at the bottom.
To achieve good adhesion, make sure surface is clean and dry.
Step six
Locate the display screen at the 12 o'clock position, and press tight. Adhere controller to the wall.
Attention: Level controller.
IMPORTANT: PLEASE place sticker that comes with unit reading, “SAFETY SIGN FOR
STEAM ROOMS OF COMMERCIAL STEAM BATH GENERATORS MENTIONED IN 66.4” on a
visible location to
pass inspection requirements.