Installation Guide

ManualsBrandsSteam Planet ManualsBathKascade Hinged 59 in. x 32 in. x 84 in. Center Drain Alcove Shower Kit in Black and Chrome Hardware with 8 Body Jets

1 | P a g e

Rev 01.2019

KASCADE SHOWER ENCLOSURE

INSTALLATION GUIDE

Summary of content (6 pages)

PAGE 1
KASCADE SHOWER ENCLOSURE INSTALLATION GUIDE 1|Page Rev 01.
PAGE 2
Table of Contents IMPORTANT INFORMATION: ------------------------------------------------------------------------------------------------------------------------ 3 PARTS LIST: ---------------------------------------------------------------------------------------------------------------------------------------------- 3 DIMENSIONS: ------------------------------------------------------------------------------------------------------------------------------------------- 3 RECOMMENDED: ------------------------
PAGE 3
IMPORTANT INFORMATION: This unit can be assembled as a right hand or left-hand unit. The main control panel and the 5in elevated platform on the base (G) determines the direction. PARTS LIST: A. B. C. D. E. F. G. H. I. J. K. L. M. N. O. P. Q. R. S.
PAGE 4
ASSEMBLY INSTRUCTIONS: 1. Make sure there is enough space to set the base in place (32 X 60) and 85 in for height. 2. Determine which direction of the unit is appropriate I.E. left or right. The 5in elevated platform of the base is where the wet wall will be. 3. Connect the shower base drain to the base and set the base in place using Thinset or some other support material to level the base and support it. 4. Place the foam tape in the channel of the base to support the glass panels.
PAGE 5
8. Attach the shower wand bracket to the control panel. 9. Before installing the main control panel, make sure all the fittings and connections are tight. 10. Set the control panel (A) in the channel of the base and slide it into the corner gasket and secure it to the back panel with angle brackets and bolts. Connect the braided water lines to the hot and cold-water supply. Check for leaks. 11. Install the small support bracket (R) near the front top of the unit on the main control panel.
PAGE 6
14. Next install the 28 in bar on the inside of the shower. It will bridge panel (E) and panel (F). Move the glass panels so the edges are straight up and down and plumb so the door will fit properly, secure the brackets in place. The opening for the door should be very close to 24 ¼. 15. When installing the door (G) make sure the edges of the left and right-side front panels are straight up and down. When installing the hinges there will be several plastic spacers with each hinge.