Installation Guide

5 | P a g e
Rev 01.2019
8. Attach the shower wand bracket to the control panel.
9. Before installing the main control panel, make sure all the fittings and
connections are tight.
10. Set the control panel (A) in the channel of the base and slide it into the
corner gasket and secure it to the back panel with angle brackets and
bolts. Connect the braided water lines to the hot and cold-water supply.
Check for leaks.
11. Install the small support bracket (R) near the front top of the unit on the
main control panel. Make sure the control panel AND the front panel (E)
are straight up and down and plumb. This bracket will stabilize the
control panel and the hinge side panel when the door is installed.
12. Attach the third and final corner gasket to the outside edge of the non-control side panel (C). Slide the
clear glass panel (F) into the gasket channel and secure it with the angle brackets and bolts.
13. Install one of the half moon gaskets on the outside edge of the main control panel (A), and place the
clear panel with the stripe on it (E) into the channel. This will squeeze the half -moon gasket and make
a water tight seal. Secure in place with angle brackets and bolts there should be an approximately a
one - inch gap from the outside edge of the panel and the wall.