Contemporary Steam Room Models: M6023 Installation & Operation Manual LEFT HAND UNIT PICTURED In order to operate and use the product properly, please follow all instructions provided in this User’s Manual. Our company reserves the right to change the Manual at any time. The manual takes effect the date it’s published. This manual shall prevail if there is any difference between this and previous documents and manuals. Rev 07.
Table of Contents NOTICE TO INSTALLERS ........................................................................................................................................................... 3 PACKING NOTE ........................................................................................................................................................................ 3 ASSEMBLED PRODUCT DIAGRAM .........................................................................................................
NOTICE TO INSTALLERS 1. The overall height from the ground to the ceiling has to be minimum of 85in for the enclosure. 2. The water pressure has to be more than 55-75 psi and, if the pressure is lower than required, you may install a booster to the water supply. 3. Please use a 20-amp 220V GFI breaker for the electrical connection. 4. We advised to have an access panel installed on the side of the electrical/water connections for maintenance and service. 5.
PRODUCT FEATURES ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ ➢ Steam and Shower Enclosure Low Threshold 2.75″ H Base included 3.5kW Quick heating Self-Draining Steam Generator w/Steam Aromatherapy Cup 8 Body Massage Jets Hand-held Shower w/ Various water massage settings & adjustable height bracket 8 in.
GLASS A：Glass A—Main Panel, Black/White B：Glass B—Solid Back Panel, Black/White C：Glass C— Front Clear Panel with Stripe D：Glass D—Top, Black/White E：Glass E—Large Fixed Clear Panel with Top Stripe F：Glass F— Clear door, strip on top. *Diagram shows Left-hand unit.
INSTALLATION INSTRUCTIONS Note: Confirm the drain setup. When installing, make sure each panel is level, plump & 90-degree before securing completely. 1. Place shower tray in the corner where it will be permanently located. Note: The handing (R/L) of your unit determines which side the 5in mounting plate/shelf goes 2. Determine placement of Steam Generator, water and electric supply. 3. In the parts box is a roll of a foam type tape with one side that has an adhesive on it.
9. Electrical Connections: The wires for the fan, speaker, and light are labeled. Make the corresponding connections from the accessory to the wire coming from the control box. *Note: Be cautious when making this connection. The pins of the connector can easily bend if connected improperly! A: Wire for control panel B: Temperature Sensor C: Wire for speaker/fan/light D: Speaker E: Fan F: Lights G: Connecting terminal for light/fan/speaker H: Control panel connecting terminal 10.
14. Assemble the half-moon shaped seals on the sides A, and C of glass D (top), if needed. See illustration below. Attach angle brackets to glass panel D. Note: The fan and speaker side of the glass will hang over the main control panel side. Place glass D (top) on the top of the unit, align connecting holes with glass D to glass panels A, B, and C. Use connector bolt to connect. Please refer to illustration below. 15. Insert the rubber seals into the movable glass door and attach.
PFISTER HANDLE ASSEMBLY TEMPERATURE ADJUSTMENTS TRIM FLANGE ATTACHMENT Position Flange (A) on the Valve (B) with drain hole (C) at the bottom. Place Protective Washer (D) on the short end of the reversible Retainer Sleeve (E). Screw Retainer Sleeve (E) onto threaded section of the Stem and Bonnet (G). Tighten Retainer Sleeve (E) by hand until Flange (A) is snug to finished wall surface. If the short end of the Retainer Sleeve (E) is too short, reverse it to use the longer end.
MAINTENANCE & CARE Disassembly: 1. Replacement parts may be available at Lowes or Home Depot. 2. When replacement parts are not available, please write or call Price Pfister Consumer Service. 3. Always turn off water and release pressure before working on your faucet. Note: Trim Care Cleaning instructions: For all Handles and decorative finishes, use only a soft damp cloth to clean and shine. Use of polish, detergents, abrasive cleaners, organic solvents or acid may cause damage.
FAUCET FUNCTION AND USAGE • • • • • Water Diverter handle o Turn the diverter handle according to the signs marked on its face. When you use the hand held shower, turn the knob to the hand held shower sign; When you use the massage jets, turn the knob to the back-massage sign. When you use the rainfall shower head, turn the knob to the rainfall shower sign Cold Water and Hot: o Turn the faucet to left and right to increase/decrease the water temperature.
S198E KEYPAD USER MANUAL KeyPad Diagram 1.Crystal display 2.Power button 3.Shuttle switch 4.Volume adjust button 5.Previous 6.
KEYPAD OPERATIONS INSTRUCTIONS Press on button – Keypad will light up NOTE: When keypad has not been used for 30 seconds the locked symbol on the right side of the keypad will light up. To get out of locked mode press the Shuttle Knob If you rotate the Shuttle Knob and it doesn’t move, make sure it is not in the locked mode. Rotate the Shuttle Knob and the Various options will become highlighted on the Crystal Display (keypad).
To control the music Volume with the Keypad, Highlight the i MUSIC, PRESS the Shuttle Knob. Press the Speaker button on the bottom left of the keypad and the dB on the display will flash, rotate the Shuttle Knob to the desired volume, press the Shuttle Knob to set. While in Bluetooth mode you can receive call and talk through the microphone. If you have a waterproof phone you can make calls also. To answer incoming calls, press the shuttle knob.
