Installation Guide

Rev 06-2019

Door Installation Help

When assembling the MA 60XX series units, the door can sometimes be the most challenging aspect of this unit. Following these few

tips can make the installation much easier.

First note, on one or two (depending on the model) of the glass panels is a “notch” on the bottom. It is imperative the notch be moved

as far as the base will allow; this should give you an overhang of the side panel over the base about 1/8 to 3/16 in. If you do not have

the glass positioned with the overhang there will not be enough space between the door and the side panel to enable the magnetic

strips to make proper contact.

When installing the panels together, make sure the panels are straight up and down and at 90-degree angles to each other. The

panels can be put together slightly off but when you go the install the door you will have some difficulty. Make sure the edges are

straight up and down on all the panels especially the panels that will form the door.

Once you have followed the above procedures following these l instructions will make installing the door easier. When you take the

hinges out of the box you will notice there are quite a few plastic spacers attached to the hinges. Make sure you place ONE spacer

between the metal hinge body and the door on both sides of the hinges EXCEPT the bottom out side hinge on the stationary panel.

That hinge and only that hinge gets two spacers (the bottom outside only.) Putting the extra spacer on the bottom will eliminate most of

the problems with the door closing properly.

Note

Slamming and quickly closing the door will sometimes pop open the door. You have to slowly close the door, the unit is sealed pretty

well because it is a steam room, the only way for air to get out is through the fan opening in the top, so if you quickly close the door, the

air can compress and force the door open until the pressure is equalized, slowly closing the door will allow the air to escape. Also, the

fan is not an exhaust fan it is a recirculating fan, it blows air into the unit so having it on will not help closing the door.