Installation Guide

8
Rev 06-2019
15. Attach glass panel E which has a black stripe across the
top and side to glass panel D and A. Note: On the front
panel E there is a “notch” on the bottom. It is imperative
the notch be moved as far as the base will allow; this
should give you an overhang of the side panel over the
base about 1/8 to 3/16 in. If you do not have the glass
positioned with the overhang there will not be enough
space between the door and the side panel to enable the
magnetic strips to make proper contact.
16. Insert the corner seal and corner brackets on the left side
of glass F (will have holes for door hinge) attach to panel
D & C with angle brackets and connector bolts. Attach
door hinges and door Panel G.
Note: Read the Door Installation Help on page 9.
17. Put the wood floor grids in the shower tray and benches in
the unit. Attach flexible waterline to outlet on panel A and
the other end to the handheld shower wand. Attach to the
bracket. Note: the hex nut of the water line goes on the
panel outlet.
18. Attach handle to the door and shelves to panels B and C.
19. This gasket must go between the magnetic gasket and the
bubble gasket on the hinge side. The magnetic gasket
and bubble gasket must extent down to almost touching
the base top otherwise there could be some leaking.
20. Steam Cup Connection Diagram
A: Steam outlet
B: Steam line
Connector
C: Glass
D: Steam hose