Manualshelf

Installation Guide

ManualsBrandsSteam Planet ManualsBathSuperior 9kW Deluxe Self-Draining Steam Bath Generator Digital Programmable Control in White and Chrome Steam Outlet
12345678910
8
Rev. 8.2018
Note: Aromatherapy oils are placed in the indentation at the top of the steam nozzle.
Attention: In order to protect the steam nozzle, do not use any tools to tighten that will scratch finish, use a little soapy water and soft
sponge to wipe, and do not use corrosive chemical solutions or abrasive cleaning tools.
Attention:
Please consult your distributors of building materials like acrylic, fiberglass or other heat-resistant material around the installation and
position of steam nozzle. It is suggested that MS-103412 heat resistant material is used.
Drainpipe (1/2'')
According to national and local codes, the steam engine drain valve should be equipped with drainpipe. The drainpipe must be able to handle
200-degree water. The steam engine will drain water on its own after 20 minutes. It is a gravity drain.
Attention: drainpipe should not incline upwards.
Safety valve (Pressure Release Valve)
1. Safety valve is to prevent too much steam pressure in the interior steam engine.
2. The pressure limit range of safety valve is 10 PSI. If the pressure should become too high over this value, the valve will release the
pressure.
Attention:
1. For safety, do not dismantle the pressure release valve.
2. To maintain the proper and automatic operation of pressure release valve, make sure the connection is tight.
WARNING!
The steam nozzle and steam outlet are very hot! Avoid installing the steam nozzle near steam bathers.
1. Install the steam nozzle 6-12 inches above the ground.
2. The steam spray outlet should be installed face down. Wrap a few circles of Teflon tape around
the threads of the steam pipe, install the steam nozzle and tighten with hands.
DANGER!
1. Installer la tête d’injection de vapeur enter 15 et 30 cm au-dessus du sol. Si le bain de vapeur se
trouve dans la baignoire ou la salle de bains, installer la tête d’injection de vapeur à 15 cm au-
dessus de la baignoire
2. Le jet de vapeur doit être dirigé vers le bas. Entourer le filet du tuyau de vapeur de quelques
couches de Teflon, visser la tête d’injection de vapeur et visser manuellement