Installation Guide

16
Rev. 8.2018
PART 2: CONTROL PANEL
Cleaning Instructions
1.Use soft cloth with a little soap water to clean the
controller.
2.Do not use abrasive cleaning tools or material.
Safety and operation information
Warning: If the installation and operation instructions
are not read or understood, do not install or use, to
prevent serious damage or injury. Install the controller
based on the installation instructions, otherwise, the
temperature in the steam room will be too high or will not
heat properly.
If the controller is installed outside the steam room, the
temperature sensor must be installed in the steam room.
Operate based on the instructions otherwise the controller
may lose control or the bathroom will be overheated.
Caution: Do not install the controller wire in the
same wire rabbet with any other wire. Do not get
close to hot water or steam pipe otherwise the
controller may not operate properly or the bathroom
will be overheated.
Important: Before installing the controller, make
sure the power to the steam generator is shut off
otherwise the controller may not operate properly or
get damaged.
Do not use controller other than as described with
this steam generator. Do not use the controller to
operate steam generator of other brands otherwise
the controller may not operate properly or the
machine will get damaged.
The instructions include important safety, operation
and maintenance information. Keep the instructions
readily available.
If the steam generator is damaged or not running
properly, do not continue to install or use the
controller.