Installation Guide
Table Of Contents
- READ ME FIRST
- COMMON INSTALLATION PROBLEMS:
- WARNINGS:
- MANDATORY READING
- PART 1: STEAM GENERATOR
- USER INSTRUCTIONS
- CHOOSE YOUR TYPE OF MACHINE
- MAINTENANCE
- STEAM GENERATOR CLEANING
- SENSOR PROBE REMOVAL FOR DIRECT CLEANING
- CHOOSING PROPER LOCATION
- INSTALLATION DRAWING OF THE STEAM GENERATOR
- INSTALLATION OF STEAM LINE
- BLUEPRINT FOR THE STEAM ENGINE
- ELECTRICAL REQUIREMENTS:
- AMPERE METER
- ASSEMBLY GRAPH FOR POWER WIRE
- Wiring Diagram 220-240V (1PH/2PH)
- INSTALLATION OF THE TOP LIGHT
- STEAM GENERATOR CONFIGURATION
- TROUBLE SHOOTING:
- DELUXE KEYPAD ERROR CODES
- INSTRUCTIONS FOR RESETTING THE MANUAL HI-LIMIT SWITCHES
- SPECIFICATIONS
- PART 2: STANDARD CONTROL PANEL
- PART 3: DELUXE CONTROL PANEL
- PART 4: ADDITIONAL INFORMATION
12 | Page
NOTE: NOW AVAILABLE FOR THE GS08 STEAM GENERATORS
LED Lighting Kits - White or Chromotherapy Lights
Hole for light is 1 13/16in. Diameter of light is 2 3/16in. Length of light is 1 1/2in
Drip Pan - 20x10x1 and weighs 3 lbs
*For pricing, please contact your place of purchase
INSTALLATION OF THE TOP LIGHT
Attention: 12V output port is available for 12V DC accessories (not included).
The total draw on the 12V circuit cannot be more than 35W
Attention: Do not let the electrical components be exposed to moisture; otherwise, it may cause damage or short circuit.
Caution: The illustration is just for explanation, the practical installation must comply with the national electric code, and installed by
professional electrician.
Note: The Temperature Sensor MUST be as far away as possible from the steam outlet and inside the room. It should be about
shoulder high where occupant will be sitting.
The steam outlet must be far away from any occupant to prevent burning.
The keypad can be mounted inside the room or outside.
The keypad must not be placed in direct contact with water spray.