Installation Guide

17 | Page
CONTROLLER INSTALLATION INSTRUCTIONS
Attention: Before installing the controller, make sure the steam engine is shut off.
Step one
Determine the installation location of the controller.
For installation:
1. 4 -5 feet away from the ground or convenient height inside or
outside the room.
2. Locate controller on separate wall from steam nozzle.
3. Do not expose yourself to the direct spray of steam.
The controller wire is 1.5 feet long with a controller extension wire going to the steam engine being 19.5 feet long. Installation of
controller panel should be in a position not more than 21 feet from the steam engine.
Attention: Do not install the controller under the water pipe or in a position where it will be
sprayed with water.
Step two
Drill a round hole of 1.4” in diameter in a chosen position. Or see note.
Step three
Pull the controller wire through the round hole, connect it to the corresponding wire in the engine.
Attention: Do not over tighten or clip the controller wire.
Step four
Start the power for the steam engine, check and adjust connection, check each item on the
keypad to make sure everything is working properly.
Attention: Before setting the controller, make sure the steam engine is shut off.
Step five
Remove the paper at the bottom.
To achieve good adhesion, make sure surface is clean and dry.
Attention: Level controller.
Step six
Locate the display screen at the 12 o'clock position and press tight. Adhere controller to the
wall.
NOTE: The controller/keypad can be mounted flush on the wall. A rectangular opening that is 5 3/8”x3 5/8” needs to be cut out.