Installation Guide

18 | Page
TEMPERATURE DETECTOR INSTALLATION
1. The position of the temperature sensor should be about shoulder high where occupant will be sitting. Avoid installing near the
steam outlet.
2. As shown in Fig.1, drill a small hole (3/8”) in the selected position.
3. Apply silicone along the edge of the back of the detector foundation (as shown in Fig.2).
4. Use a locknut to lock the detector foundation. (As shown in Fig.2)
5. Push the temperature detector and go through the back of the detector foundation (As shown in Fig.3)
6. The temperature detector should be installed by extending about 3/8” from the front of the room for accurate temperature.
7. Apply silicone to the back and set the detector. (As shown in Fig.3)
CONTROLLER PANEL ILLUSTRATION
1. Power ON/OFF
6. LED Screen
2. Steam Indicator LED
7. Steam Time Adjust Key—Low
3. Steam Temperature Adjust Key--Low
8. Steam Time Adjust Key—High
4. Steam Temperature Adjust Key--High
9. Power Indicator LED / standby
5. Water drain Key—Manual Override
10. Mood Light ON/OF
Note: The unit will automatically drain 20 minutes after the unit has been off