Installation Guide

20 | Page
PART 3: DELUXE CONTROL PANEL
CLEANING INSTRUCTIONS
1. Use soft cloth with a little soap water to clean the
controller.
2. Do not use abrasive cleaning tools or material.
SAFETY AND OPERATION INFORMATION
Warning: If the installation and operation instructions are
not read or understood, do not install or use, to prevent
serious damage or injury. Install the controller based on the
installation instructions, otherwise, the temperature in the
steam room will be too high or will not heat properly.
If the controller is installed outside the steam room, the
temperature sensor must be installed in the steam room.
Operate based on the instructions otherwise the controller
may lose control or the bathroom will be overheated.
Caution: Do not install the controller wire in the same wire
conduit with any other wire. Do not get close to hot water or
steam pipe otherwise the controller may not operate
properly or the bathroom will be overheated.
Important: Before installing the controller, make sure the
power to the steam generator is shut off otherwise the
controller may not operate properly or get damaged.
Do not use controller other than as described with this
steam generator. Do not use the controller to operate steam
generator of other brands otherwise the controller may not
operate properly or the machine will get damaged.
The instructions include important safety, operation and
maintenance information. Keep the instructions readily
available.
If the steam generator is damaged or not running properly,
do not
continue to install or use the controller.