Installation Guide

22 | Page
Step Five:
TEMPERATURE DETECTOR INSTALLATION
1. The position of the temperature detector should be about shoulder high while sitting and as far away as possible from the steam
head. Avoid installing near the steam outlet or room door.
2. As shown in Fig. 1, drill a small hole of 3/8in. in the selected position.
3. Apply a circle of silicone along the edge of the back of the detector foundation (as shown in Fig 2)
4. Use a lock nut to lock detector foundation. (as shown in Fig .2)
5. Let the temperature detector go through the back of the detector foundation (as shown in Fig. 3)
6. The temperature detector should be installed by extending about 3/8 in from the front of the room to make sure the speed and
accuracy of the temperature control is correct.
7. Apply glue to the back and fix the detector. (as shown in Fig. 3)
Step Six:
Remove the cover paper at the bottom. To achieve good adhesion effect, keep the sticking
surface clean and dry.
Important: To ensure horizontal installation of the controller, use a level.
Step Seven:
Locate the display screen in the vertical direction of
12 o’clock and press the controller to stick it to the wall.