Installation Guide

Rev. 8.2018

The unit will display the default time (6) and ambient temperature (5). To find out the default temperature

press the temperature adjustment button (4).

The unit will fill with water and after a few minutes begin to produce steam

Once the unit has been shut off either by the time setting or manually pressing the on/off button (1), the

automatic drain function of the generator will engage after about 10 minutes. If you do not want to wait for

the automatic drain to engage, you can override it by pressing the Light/Manual drain button (2). This will

start the drain process immediately.

While the unit is in operation, you would press the Light/Manual Drain (2) button to engage the light feature

of the system.

Temperature conversion: C to F or F to C. While the system is in standby mode, press and hold the

thermostat button (4) for 2 seconds.

Make sure the unit is running by pressing the on/off button (1)

The default time and temperature will be displayed and the unit will start to fill with water.

1. TO CHANGE THE TIME FOR THE CURRENT SESSION ONLY, press the time button (3), the

hour will flash (6). Rotate the fly shuttle (7) to the desired hour, press the fly shuttle (7) to set the hour. The

minutes will start to flash (6), rotate the fly shuttle to the desired minutes, then press the fly shuttle (7) to set

the desired time.

2. TO CHANGE THE TEMPERATURE FOR THE CURRENT SESSION ONLY, press the

temperature button (4) and the temperature display will begin to flash (5). Rotate the fly shuttle (7) to the

desired temperature (5) and press the fly shuttle (7) to set the temperature. The Steam temperature range is 25

C to 68 C or 78 F to 155 F.

Changing the default values

Make sure the unit is running by pressing the on/off button (1)

To change the default time

1. Press the time button (3) on the keypad. The hour setting will flash (6).

2. Rotate the fly shuttle (7) to the desired time. Press fly shuttle button (7).

3. The minutes display will start blinking (6). Rotate the fly shuttle button (7) to the desired minutes.

4. Press the timer button (3) for a few seconds or until a beep is heard.

5. New default time is set.

To change the default temperature

1. Press the temperature indicator (4). The display (5) will flash current temperature setting.

2. Rotate the fly shuttle (7) until the desired temperature is displayed (5).

3. Press and hold the temperature indicator (4) for a few seconds or until a beep is heard.

4. The new temperature is set.

Brief trouble shooting guide

E1. Water level sensor failure. Check the main cable connection at the steam generator and

keypad.

E2. The temperature sensor has shorted out.

E3. The temperature sensor is defective