Royal Luxury Series Installation & Operations Manual WS-102 WS-105 Note: You must read all installation & operation instructions prior to assembly and use of this unit.
Table of Contents Notice to Installers Tools Needed for Installation Product Features Unit Information Electrical Information Plumbing Requirements General Information Installation Instructions for WS102 & WS105 Cleaning & Maintenance Steam Generator Cleaning General use & Maintenance Control Parts Information LCD Display Information Control Panel Information Control Procedures Wireless FM Transmitter Information Troubleshooting ……………………………………………. ……………………………………………. ……………………………………………. …………………………………………….
NOTICE TO INSTALLERS (if applicable) THE FLEXIBLE DRAIN HOSE THAT IS INCLUDED WITH THIS UNIT IS FOR INSTALLATION INTO AN OPEN FLOOR DRAIN ONLY. SUBSTITUTING THE EXISTING DRAIN SHOE FOR A DIFFERENT ONE WILL NOT VOID THE WARRANTY AS LONG AS THERE NO DAMAGE OR EVIDENCE OF MISUSE TO THE BASE. IF A DIFFERENT DRAIN SYSTEM FOR THE SHOWER IS USED, THE STEAM GENERATOR MUST A HAVE DRAIN CONNECTION AVAILABLE TO DISCHARGE THE WATER INTO THE MAIN SHOWER DRAIN.
PRODUCT FEATURES DESCRIPTION WS102 WS105 4.
ELECTRICAL INFORMATION 1 dedicated 12-2 wire with 20 amp GFCI breaker (220V) Connect the overhead light, speaker, fan, CD, telephone according to the tags on the wires. Do not connect the wire “O3” to anything. Connect main power supply. PLUMBING INFORMATION The unit is equipped with 3 ft. hot and cold, metal braided water supply hose with ½-inch national pipe thread to connect from faucet/manifold (Manifold is located. 4 ft.
INSTALLATION INSTRUCTIONS FOR WS102 & WS105 1. Level the tray with the level. 9. Inspect and tighten the body jets and hoses if necessary 2. Make sure all the adjustable feet are touching the ground and supporting the base. 10. Install the left and right side black back walls. 3. Connect the drain if building the unit in its final resting place. Note: This unit can be built from the inside. 4. Assemble curved, horizontal rail to left and right vertical rails using ST4X40 screws. 11.
INSTALLATION INSTRUCTIONS FOR WS102 & WS105 18. Reinstall the aluminum strips near the back panel. 15. Connect fan, light, and radio wires to the roof. Install the roof of the shower cabin using ST4X12 screws 16. Install the sliding doors. Spring loaded rollers go on the bottom. 19. Adjust the sliding doors so that they close tightly. 20. Attach the door gaskets. 17. Install the door handles. 21.
CLEANING AND MAINTENANCE FOR ALL UNITS 1. Liquid detergents and soft cloth should be used. Do not use any abrasive cleaners. 2. The scale on the surface can be cleaned with a soft cloth and non abrasive cleaner or heated vinegar. 3. After every 30 times of using the unit, we suggest you to clean the steam generator. We advise the use a filtration system for the steam generator unit.
CONTROL PARTS INFORMATION FOR STEAM SHOWER FOR ALL UNITS 1. Steam Temperature Sensor 2. LCD Display 3. Control Panel 4. Water Diverter 5. Water Flow Adjustment (On/Off) 6. Water Temperature Adjustment 7. Body Jets 8. Steam Outlet 9. Handheld Shower Set 10.
LCD DISPLAY: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
CONTROL PROCEDURES Power on/off Push any button to light the display, and press the power on/off switch to start the system. Push the power on/off switch again to turn off the system and display. Steam Temperature Setting Touch the Steam Temperature Setting button and the display will appear on the screen. The temperature ranges from 20°C to 59°C circularly. Let go of the button when the desired temperature has been reached, and the figure is set as a steam setting.
Channel Memory Channel Memory Setting: o Start FM Radio o Set serial number touch button and touch this button when the wanted fissure shows. button again, fissure from 1 to 8 shows circularly; stop touching o Adjust FM Radio to your favorite channel; touch button to adjust frequency and volume. Channel Memory: Touch button for more than 3 seconds; the figure shows +1 and turns to original setting station number. Release button to finish setting for one channel.
WIRELESS FM TRANSMITTER On/Off: Push and hold this button for power on/off. Push and release this button shortly to change between transmitting and clock. Audio signal input: to be connected to audio signal output interface of Mp3 player. Transmitting frequency +/- adjusting: push this button to increase/decrease for transmitting frequency for FM. The adjusting range is 88-108.8MHz.
TROUBLESHOOTING FOR STEAM CABIN ISSUE Touch panel does not work CAUSE 1. Not connected properly 2. Wrong voltage No steam Steam generator keeps adding water Power supply is off when on/off button is pushed SOLUTION Check connection between control panel and power box 1. Desired steam room temperature is lower than current temperature Change to 220V supply Increase the desired temperature to be higher than current temperature 2.
| P a g e Rev 10/2012
| P a g e Rev 10/2012