Installation Guide

Rev1/2015
6 | P a g e
INSTALLATION INSTRUCTIONS FOR WS112 ALL SIZES
1. The distance between Wall A and Wall B should be at least
1510mm (59.5 inches).
2. The minimum height for the unit (not including any base) is
84.5 inches.
1510mm to 1530mm = 59.5” to 60.3”
DOOR FRAME ASSEMBLY
Note: For California only: Attach the door frame brackets with
self-tapping screws and expanding bolts.
1. Bottom horizontal rail has wide opaque gasket, top
horizontal rail has grey gasket
2. The 5inch side panel trim piece has to be removed to
expose assembly screw holes
3. Check on top and bottom horizontal rails the screw holes are
tapped
Note: if they are not tapped , tap before assembling
4. To assemble front frame you will need at least 6” #2 Philips
bit. It is advised to use an impact driver. Do not over tighten.
5. Each 5” frame sidepieces has 2 grey rubber gaskets on top
and bottom.
Bottom piece has to be all way down, top piece – all way to
the top.
6. Assemble horizontal rails to wide vertical rails with ST4X50
self-tapping screws.
INSTALLING SHOWER WALLS
Note: It is advised to assemble to soap dish with M4X25 screws
(2 screws, 2 nuts, 2 bolts, 2 brass washers, and 2 caps) before
putting any panels together. Also attach the sliding bar for the
handheld shower on the left side. Hardware is inside cloth bag.
1. Place large back panel on back side of base.
2. Remove trim piece from right side of left side glass panel.
This will expose the assembly screw holes.
3. Attach Power supply and water supply to the left side panel.
4. Attach left side panel to back panel using ST4X16 self-
tapping screws (pre-drilled holes should line up)
5. Attach right side panel in same fashion as previous step.
6. Attach the front glass frame that was assembled before
using the ST4X16 self-tapping screws.
7. Run the drain hose from the steam box through the small
hole on the bottom center of the left side panel. Hose should
extend into shower room. (Will be covered by wood grids)
8. Seal unit to the acrylic base along the walls leaving the
corners open.
9. Secure unit to base (acrylic base/ do not drill stone base)
10. Attach all sides with tapping screws and blocks
11. Apply silicone to seal the gap between panels and floor.
Leave the corners without silicone.