Owner Manual

Steam Ranger

Installation, Operation & Maintenance Manual

A. Installation

Install the controller inside/outside the steam room, and, preferably, beside the

door, where you can have easy access. Run the sensor wire in the wall, and then

protrude the probe head into the room. The best location for sensor is 5” above

the door level and the sensor tip should be exposed 1.5” into the room, also

further away from steam head. It is recommended to use the optional sensor

cover to improve the accuracy and to protect the sensor tip.

Note: The controller is provided with a 25 ft. standard-length connector cable and a 20 ft. sensor cable. If

you need to extend them up to 50 ft., use 2-core wires for the sensor, and 4-core wires for the

connector cable (22 to 18 AWG).

B. Operation

1. ON/OFF: Turns on or shut off the steam. When the control is in standby mode, the ON/OFF light stays on.

2. Time control: Controls the duration of steam operation. The unit will work until it times out. To change the

time setting, press and release the TIME button while the control is turned on, use the ▲ (Up) or ▲ (Down)

buttons to set it on desired time, then press and release the SET button to save it, or ON/OFF button to undo

changes.

3. Temperature control: Controls the temperature setpoint in the steam room. To change the temperature

setpoint, just press and release the TEMP button, while the control is turned on, use the ▲ (Up) and ▲ (Down)

buttons to set it to desired value, then press and release the SET button to save it, or ON/OFF button to undo

changes.

4. Temperature display: When the control is turned on, it displays the current temperature in Celsius and

Fahrenheit in the steam room. To see the remaining time, simply push the Time button, the display goes back

to temperature reading if no other button is pushed.

5. Celsius to Fahrenheit: To switch the display reading between Celsius and Fahrenheit, first, turn off the

control through the ON/OFF button. Then press the ▲ (Up) and ▼ (Down) buttons together for about 5

seconds until the “f” light turns on.

6. Lights (LEDs): There are 4 lights around the display, each indicating a status:

• ON/OFF: is on when the control is turned off in

Standby mode.

• TIME: is on when the timer is still counting down.

• TEMP: is on when there is a call for steam.

• °f: is on when the display reading is set for

Fahrenheit.

7. Default Setpoints: The control goes back to the

following default settings when the power is

interrupted.

• Temperature defaults: 47°C (117°F). Set range: (0

to 90°C)/(0 to 194°F).

• Time default: 60 minutes. Set range: 1 to 255 minutes.

BREGUETI Touch Control