Owner Manual

SteamSpa PHONE: [phone] FAX: [phone] http://steamspa.com [e-mail]
Page 21
INSTALLATION & USER GUIDE
CONTROL PANEL OPERATION
The control panel has a digital temperature control system which can start, stop or pause in the
preset time to keep the temperature at the set number.
ON/OFF
When system is powered, all functions will still not be activated and remain in a waiting state.
Digital tube will display ---- (Fig.1). In the waiting state, press the button to turn on the system
and activate steam function. System will recall last use steam time and TEMP, system begins
to count down. During this time, the digital tube will display the ambient temperature. Steam
temperature display range is 32° F-140° F.
When the actual temperature is lower or equal to 32° F, the digital tube will display 32° F. When
the actual temperature is higher or equal to 140° F, the digital tube will display 140° F. The last digit
displays as the unit (Fig.2) of Fahrenheit temperature. The default steam time is 30 minutes.
When lacking water, the heating elements will stop heating and the water inlet valve will work
automatically. If there is no water detected in 5 seconds or the water coming in does not reach the
set point in 15 seconds, the digital tube will display (Fig.3)to indicate an error of not enough
water cycling. If there is enough water cycling, the steam function will return to normal. When
the steam function is started, if the ambient room temperature is higher than the set point, the
heating element will stop heating, the digital tube will flash to display the current environment
temperature; when the environment temperature is lower than the set point, the heating element
will work again, the digital tube will display current room temperature normally.
When the system is on, press button to turn off the system, or when the steam time is over
the system shuts off. 2 hours after the system is shut off, the drainage function will be started
automatically for 5 minutes.
TIME AND TEMPERATURE SETTING
When system is on, pressing the button will cycle the system between the Time setting,
Temperature limit setting, and ambient TEMP display on the LED screen(Fig.4). When system
is powered on, press button one time to adjust Steam time. Its range is 1-60 minutes,
with 1 minute intervals, which can be adjusted using the and arrow keys. If there
is no adjustment in 5 seconds, the system will exit time setting automatically and the LED will
display current ambient TEMP. Pressing the twice will allow you to set the Temperature limit
setting. During this time, press or to adjust steam TEMP (Fig.5). Its range is 50°~130°
Fahrenheit, with 1° increments. If no adjustment is done in 5 seconds, the system will exit the
TEMP setting automatically, and the LED screen will display ambient temperature.
MEMORY FUNCTION
Press the memory button, , to select which memory setting you would like to program,
SET1 or SET2. Then use the to set the desired Time and Temp setting for that memory slot.
Once you have set the time and temp as desired, press and hold the button for 1.5 seconds
to save the setting , then LED display will flash the name of the selected memory slot that was
programmed. When the system is on, you can now press to switch to your desired memory
preset, SET1 and SET2, and the control will automatically adjust the time and temp to the saved
setting.
LIGHT FUNCTION
When the machine is started, press button to turn on/off light function. When the light is turned
on, the digital tube will temporarily display (Fig.6). When the light is turned off, the digital tube
will temporarily display (Fig.7). Screen will turn to display ambient TEMP if no operation is
selected in 5 seconds.
Fig.1
Fig 2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7