Owner Manual
Table Of Contents
- Prologue
- User Instructions
- Choosing the Right Location
- Installation Drawing of Steam Generator
- Plumbing Installation
- Steam Generator Specifications
- Electrical Requirements
- Assembly Graph for Power Wire
- Installation of the Top light
- Steam generator DISSECTION DIAGRAM
- Care & Use for the control panel
- Controller Box Content
- Control Panel Installation instructions
- Testing the Machine
- Control Panel Diagram
- Control panel operation
- Steam Generator Maintenance
- Technical Parameters
- Wiring Diagrams
SteamSpa PHONE: 800-856-0172 FAX: 866-560-1060 http://steamspa.com info@steamspa.com
Page 29
INSTALLATION & USER GUIDE
PROBLEM POSSIBLE CAUSES SOLUTIONS
Receiving an error “E1” on the control
panel
1. The signal that transfers between
the control panel and generator has
a problem
1. Check the connection on the control
cable to make sure all 13 pins are
functional
Receiving an error “E0” on the control
panel
1. Lack of water in the tank. The water
inlet valve is not turning on which is
preventing water from entering
1. The water inlet valve is jammed or
the connecting cable is loose so
attempt to clean the water inlet valve
by switching it on and off a few
times to dislodge any buildup
2. Check the cable and make sure it is
firmly connected
3. Replace the water inlet valve
4. If the problem persists it may be
necessary to replace the PC board
The control panel shows the
temperature, but does not go on
1. The water level sensor cable or the
cable from the relay to element is
loose
2. The heating element is
malfunctioning
1. Make sure all cables to the heating
elements are well connected
2. Replace the heating element