Carpet Cleaner User Manual
ENGLISH
|
7
MICROFIBER PADS
1. Lay one Microber Pad on at surface, with two fastener strips facing upward.
2. Align Mop Head above Microber Pad. Make sure Mop Head is oriented with pad as shown,
and centered as best as possible (FIGURE 3-A).
3. Press Mop Head rmly down onto Microber Pad. Fastener strips will adhere to pad grips on
underside of Mop Head. Microber Pad should now be attached and ready for use (FIGURE 3-B).
CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.
NOTE: Microber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
heat or air dry setting is acceptable as well.
The Mop Head and Microber Pads are perfect for use on these hard oor surfaces:
•
Sealed Hardwood
•
Stained Concrete
•
Sealed Laminate
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces. Surfaces
that are not properly sealed may be warped or damaged by exposure to heat and moisture.
Care should also be taken when steaming sealed hardwood oors, as prolonged exposure
to steam in a single spot may cause damage and discoloration. To avoid this, keep the
Mop Head in constant motion on these surfaces.
Steam may remove the sheen from some oors that have been treated with wax.
Extremely rough textured oors may tear or damage Microber Pads.
•
Linoleum
•
Ceramic
•
Granite
•
Marble
•
Vinyl
•
Tile
FIGURE 3
A B