Use and Care Manual

English 9
Release
Ta b
MICROFIBER PADS
1. Lay one Microber Pad on a at surface, with white fastener
strips facing upward.
2. Align Mop Head above Microber Pad. Make sure Mop is
oriented with Pad as shown (Figure 1).
3. Press Mop Head rmly down onto Microber Pad. Fastener
strips will adhere to Pad Grips on underside of Mop Head.
The Microber Pad is now attached and ready for use.
4. To remove, use your foot to press down on Microber Pad
Release Tab (Figure 2) while simultaneously pulling the unit
up and away from Microber Pad (Figure 3).
WARNING: Use care when handling a recently used Microber
Pad, as it may still be hot.
Initial Setup
Figure 1
Figure 2
Figure 3
White
Fastener
Strips
Release
Tab