Everyday Fabric Steamer MODEL SF-510 Owner’s Guide Please read all instructions before use. KEEP YOUR RECEIPT FOR WARRANTY PURPOSES.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce risk of fire, electrical shock or injury, the following basic safety precautions should always be followed when using an electrical appliance. WARNING: To reduce the risk of electrical shock, this appliance uses a polarized electrical plug with one prong that is larger than the other. This plug will fit into a wall outlet only one way. If the plug does not correctly fit in the outlet, contact a licensed electrician to install a proper outlet.
10. Do not use unit where aerosol-based products are being used, or where oxygen is being administered. 11. Unit is only meant to be used with recommended Everyday Fabric Steamer (model SF-510) accessories. Using other types of attachments may cause damage to unit or injury. 12. If Lighted On/Off Switch does not illuminate when unit is plugged in and switch is set to “I” (on) position, unit is not operating normally.
Product Information The following features and accessories are included with your Everyday Fabric Steamer. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Product Support on Page 14 of this manual for Consumer Service contact information.
• The Steam Nozzle (1) emits the flow of hot, penetrating steam produced by the Boiler. The Fabric Brush connects to the Steam Nozzle. • The Pole Top (2) connects to the top section of the Telescopic Pole. The Pole Top is comprised of the Steam Nozzle Cradle and Clothes Hanger Hooks, and includes the Hanger Anchor Holes. • The Hanger Anchor Holes (2a) serve as the connection point for attaching the included Hanger. • The Clothes Hanger Hooks (2b) are included as an alternative to the included Hanger.
Assembling Your Everyday Fabric Steamer TELESCOPIC POLE The Telescopic Pole is made up of four sections (FIGURE 1): • TOP (SECTION 1) • MIDDLE-TOP (SECTION 2) • MIDDLE-BOTTOM (SECTION 3) • BOTTOM (SECTION 4) FIGURE 1 SECTIONS 1, 2 & 3 are adjustable in length. By using the three extension locks, these sections may be extended or retracted in order to achieve the desired length. Refer to Adjusting Telescopic Pole section on Page 7 for more details.
CONNECTING POLE TOP 1. Look at underside of Pole Top to locate two guide ridges (FIGURE 3-A). 2. Align Pole Top guide ridges with guide grooves on SECTION 1 of Telescopic Pole. NOTE: It is recommended to orient Pole Top so Nozzle Cradle faces backwards towards rear of the unit. 3. Slide Pole Top onto SECTION 1 of Telescopic Pole (FIGURE 3-B). Press down firmly until Pole Top fits securely in place. 3-A CONNECTING HANGER 1. Locate brackets on back of Hanger (FIGURE 4-A). 2.
Assembling Your Everyday Fabric Steamer CONNECTING HOSE 1. Place end of Hose onto threaded Hose Base (FIGURE 6-A). 2. Rotate coupling in clockwise direction until Hose is tightly secured onto Hose Base (FIGURE 6-B). Hand tighten only. Do not over-tighten. 3. Hang Steam Nozzle on specially designed Steam Nozzle Cradle (FIGURE 6-C). 6-A 6-B 6-C FIGURE 6 CAUTION: To prevent steam from causing bodily injury or damage to surfaces, always hang Steam Nozzle on Steam Nozzle Cradle when not in use.
Using Your Everyday Fabric Steamer FILLING WITH WATER 1. Remove Water Tank from main unit. 2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counterclockwise direction (FIGURE 8-A). 3. Fill Water Tank with water through Valve Cap hole. At full capacity, the Water Tank holds 46 oz (1,360 ml) of water, and will provide a continuous steam time of approximately 50 minutes. For quick steaming tasks, a smaller amount of water can be used.
Using Your Everyday Fabric Steamer GENERAL OPERATION NOTE: Be sure that Water Tank has been filled and, if desired, the Fabric Brush is connected before following these steps. 1. For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power cord into a convenient electrical outlet. CAUTION: This unit uses a polarized electrical plug, with one prong that is larger than the other. This plug will fit into a wall outlet only one way.
FABRIC STEAMING STEAMING GARMENTS: 1. To expand Hanger for use, fold the two arms upward until the lower support arms line up straight (FIGURE 9-A). Slide lock to secure arms in place (FIGURE 9-B). A garment may now be placed on the Hanger. 2. Alternatively, place garment on a clean, rust-free clothes hanger. Place hanger (with garment) on one of the Clothes Hanger Hooks (FIGURE 10). 9-A CAUTION: Use care when handling garments hanging on unit.
Storage & Care PROPER STORAGE Preparing your Everyday Fabric Steamer for storage is quick and simple. When you have finished your steaming tasks, follow the steps listed below. 1. Set Lighted On/Off Switch to “O” (off) position, and unplug power cord from electrical outlet. 2. Allow unit to cool (15 minutes for complete cooling). 3. Bring unit to a convenient sink or tub. 4. Remove Water Tank from unit. Unscrew Valve Cap and drain all remaining water from Water Tank. Replace Valve Cap when finished. 5.
Product Support TROUBLESHOOTING PROBLEM Unit fails to heat up. Lighted On/Off Switch DOES NOT illuminate when set to “I” (on) position. Unit fails to heat up. Lighted On/Off Switch DOES illuminate when set to “I” (on) position. NOTE: Always allow sufficient time for unit to heat up and begin producing steam. Excessive gurgling in Hose and Steam Nozzle / water drips from Steam Nozzle. Steam output is weak or intermittent. POSSIBLE CAUSE SOLUTION Unit is not plugged in.
Product Support REPLACEMENT ACCESSORIES When ordering replacement accessories for your Everyday Fabric Steamer, you may refer to the part numbers below. Replacement accessories may be ordered through our Web site: www.steamfast.com You may also contact Consumer Service directly: consumerservice@steamfast.com or 1-800-711-6617 FABRIC BRUSH A510-001R- HANGER A510-002R- NOTE: Due to continuing improvements, part numbers listed above may change.
Warranty Information 1 YEAR LIMITED WARRANTY Steamfast, a division of Vornado Air LLC, (“Steamfast”) warrants to the original consumer or purchaser this Steamfast Everyday Fabric Steamer SF-510 (“Product”) is free from defects in material or workmanship for a period of one (1) year from the date of purchase. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost if the Product is returned to Steamfast postage-paid.
review this product online evalúe este producto en línea évaluer ce produit en ligne www.steamfast.com/reviews Steamfast 1-800-711-6617 415 East 13th, Andover, KS 67002 www.steamfast.com consumerservice@steamfast.