User Manual

CONNECTING POLE TOP

1. Look at underside of Pole Top, and locate two guide tabs

(FIGURE 3-A).

2. Align Pole Top guide tabs with guide grooves on SECTION 1

of Telescopic Pole.

NOTE: It is recommended to orient Pole Top so Nozzle

Cradle faces forwards towards front of the unit.

3. Slide Pole Top onto SECTION 1 of Telescopic Pole (FIGURE 3-B).

Press down rmly until Pole Top ts securely in place.

CAUTION: To prevent steam from causing bodily injury or

damage to surfaces, always hang Steam Nozzle on Steam

Nozzle Cradle when not in use. Do not lay Hose on the oor

as condensation may build up, causing unwanted water

droplets in the steam.

ADJUSTING TELESCOPIC POLE

To adjust the length of SECTIONS 1, 2 & 3 of the Telescopic Pole:

1. Release extension lock directly below SECTION 1 by swinging

hinge outward as shown. SECTION 1 can then be extended /

retracted (FIGURE 4).

2. Once SECTION 1 is at desired length, close hinge to once again

secure extension lock.

3. Repeat STEPS 1 & 2 for SECTIONS 2 & 3 of the Telescopic Pole,

using the extension lock directly below each of those sections.

NOTE: It is recommended to extend Telescopic Pole to its full

height during steamer operation; this will ensure optimal

steam ow through the Hose.

FIGURE 4

FIGURE 3

3-A

3-B

ENGLISH