Manualshelf

Installation Sheet

ManualsBrandsSteamist ManualsSteam Shower Systems and ControlsSteamist Total Sense Transitional Steambath On/Off Control - Less Steamhead
12
2
1
2
1
3
Coupler
Control Cable
to Generator
Adhesive Liner
1½" Hole
located four feet
from the floor
IMPORTANT: Run the
Control Cable through
a ¾" conduit.
Coupler
To Steam Generator
IMPORTANT: The TSX-220 Control will only function in conjunction with the "TSC" model controls and will work with any of the
TSG and SMP model steam generators.
X
2
1
TSX-220 Auxilary Outside Control
Installation Instructions
Figure 1 Figure 2
Installation and Operating Instructions
03/17
Pub. No. 272-F
Steambath Control Model: TSX-220, TSX-220T and TSX-220R
- 1 -
Control Features
IMPORTANT: The TSX-220 is an auxiliary control and MUST
work in conjunction with any TSC model control. This control
must be installed outside the steam room and TSC model must
be installed inside the steam room.
1. Steam 1 / Steam 2: Press to select Pre-Set user steam
settings.
2. Blue indicator light: Momentarily lights to indicate the button
was pressed.
3. Stop Button: Press this button to stop the steam generator.
C
US
®
1. Pre-Installation - Control Location
a) The TSX-220 control must be installed outside the
steamroom. For convenience the recommended
height from the floor is four feet. Provide a 1½" hole
in the wall at this location (see Figure 1).
IMPORTANT: Multi-conductor cable must be
installed so that the end will not be buried inside the
wall.
2. Electrical Rough-in
a) Remove the multi-conductor cable from the control
packing box. Carefully route the multi-conductor
control cable from the steam generator to the
TSX-220 located outside the steamroom. Route
multi-conductor cable through a ¾" conduit to
protect the cable from damage and to facilitate
replacement if necessary (see Figure 2).
Important: Locate Publication No. 199 “Steam Bath Important Safety Instructions”. This publication includes a Warning
label that the contractor must install on the wall near the entrance to the steam room in a highly visible location. This
label and its additional safety information are packaged with the generator in the envelope containing the installation
instructions. If it is lost or missing contact Steamist (201-933-0700) for a replacement Publication No. 199. This publica-
tion along with all documents must be left with the owner.
!
®
NOTE: The TSX-220, TSX-220T and TSX-220R controls operate
and install the same way, only difference between them is the
physical shape.

Summary of content (2 pages)