Installation Sheet
2 3/4” Hole
located four feet
from the floor
Double-Sided
Adhesive Pad
IMPORTANT: Run the
Control Cable through
a ¾” conduit.
Coupler
To Steam Generator
Modular Jacks:
All modular jacks are
identical and work in
any combination.
Connect to any jack.
¾" Conduit
To Control
C
US
®
IMPORTANT: The TSC-550 Control will only function with TSG model steam generators Serial# 2020000+, and all SMP models.
Installation Instructions
Steambath Control
Installation Instructions
Model: TSC-550
Spa Control Features
• Steambath timer
• Steambath temperature
• Multiple user settings
• AudioSense™ with music
streaming over WiFi
• ChromaSense™
• AromaSense™
• ShowerSense™
• Multi language support
• Other Miscellaneous settings
NOTE: For more details see
separate operating instructions.
IMPORTANT: Control MUST be installed inside the steam room
for proper operation of the system.
1. Pre-Installation - Control Location
The TSC-550 Control must be installed inside the steam
room. For convenience the recommended height from the
floor is four feet. If a TSSH is also installed we recom-
mend a height of 4½" feet when used for both steam and
shower. Provide a 2 3/4” hole in the wall at this location
(see Figure 1).
Total Sense Touch Control
Figure 1
Figure 2 - Cable Installation on Generator
03/17
Pub. No. 310-A
- 1 -
Required Inside
Installation
TSC-550 Control.
Locate away from
the direct line of
shower spray and
do NOT locate
above steamhead.
Cleaning Instructions: Use a damp cloth and mild soap.
Do NOT use abrasive cleaners which might scratch the
surface or the base of the control.
IMPORTANT: Multi-conductor cable must be installed so
that the end will not be buried inside the wall. The unit will
not operate unless the control is installed.
2. Electrical Rough-in
Locate the multi-conductor cable (supplied with steam
generator). Carefully route this control cable from the
steam generator to the TSC-550 located inside the
steamroom (see Figure 1). Route this control cable
through a ¾" conduit to protect the cable from damage
and to facilitate replacement if necessary.
Important: Locate Publication No. 199 “Steam Bath Important Safety Instructions”. This publication includes a Warning
label that the contractor must install on the wall near the entrance to the steam room in a highly visible location. This
label and its additional safety information are packaged with the generator in the envelope containing the installation
instructions. If it is lost or missing contact Steamist (201-933-0700) for a replacement Publication No. 199. This publica-
tion along with all documents must be left with the owner.
!
®
IMPORTANT: Control may be installed in a Portrait or
Landscape orientation. Please note the “TOP” of
control prior to mounting.
Portrait Landscape