Installation Sheet
respiratory
ESSENTIAL OIL
restore
ESSENTIAL OIL
1
14
15
5
7
8
9
10
11
4
12
6
3
2
13
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
8
MEMORY 1 MEMORY 2
C
US
®
Installation Set-Up Instructions
AromaSense Option Model: TSA
Figure 1: AromaSense Module
12/11
Pub. No. 208-D
- 1 -
1. Access screw to connect the control cable (center top).
2. Peristaltic “Pump 1” (left).
3. Peristaltic “Pump 2” (right).
4. Manual forward and reverse switch for Pump 1.
5. Manual forward and reverse switch for Pump 2.
6. Peristaltic pump rollers.
7. Black peristaltic pump tube.
8. Clear Discharge tube (tube on right side of each pump).
9. Clear Suction tube (tube on left side of each pump into
canister).
10. Canister Caps drilled with 1/8’” holes.
11. AromaSense Canisters (purchased separately).
12. Bottle clips to secure essential oil canisters.
13. Tube Fitting.
14. AromaSense Adapter plug ¾ NPT.
15. Aroma Injection Tee: ¾ copper X ¾ copper X ¾ NPT.
The AromaSense optional pump system is designed to work exclusively with the Steamist Total Sense TSG generators and TSC spa
controls. This option does not work with the TSC-250 control.
!
Warning: AromaSense oils are not for oral consumption and should not be applied to the skin. Keep the Aroma-
Sense oils and the AromaSense pump out of the reach of children. AromaSense oils are not a cure or treatment for
any medical conditions. Elderly persons, pregnant women, or those suffering from heart disease, high blood
pressure, diabetes, or who are otherwise not in good health, do not use this devise unless directed to do so by a
physician. Also do not use the steam bath while under the influence of alcohol.
Figure 2: AromaSense Adapter
Installation Instructions
1. Select a location for mounting the AromaSense Module
system in a utility area or closet near the steam room.
The oil is injected directly into the steam line with an
Aroma Injection Tee (15) going to the steam head. The
distance from each pump to the tee should not exceed
SIX FEET. This tee and the clear tubing (8) that carries
the oil to the tee (15) must not be installed inside walls.
This tubing and tee must be completely accessible for
proper setup. Do not install any part of this assembly in a
wall. The location may be above or below the steam line
connection. The location should be convenient for
replacing the oil canisters.
®