Installation Guide

SteamSpa PHONE: [phone] FAX: [phone] http://steamspa.com [e-mail]
Page 26
INSTALLATION & USER GUIDE
TESTING THE MACHINE
1. Make sure the power switch of the control panel is turned on (the control panel displays ---), and the water supply valve will
open.
2. Press the steam switch, , the control panel will display the temperature of the environment, the steam engine begins to input
water to start the steam function, and while opening the steam, press the button to open light function.
3. When there is steam output, press again, the steam will stop and the light will go off automatically.
4. Press the button to start the steam, the steam will come out of the steam generator in no more than 1-2 minute. As time goes
on, the temperature displayed in the control panel will rise with the temperature in the room before it stops and stays at the set
temperature.
5. Based on different requirements of the user for temperature and steam time, the control panel can adjust temperature and
steam time.
6. When the set steam time is due, the system will shut off the steam and light function automatically to stop water input and
steam production .
7. 30 minutes after the steam is shut off, the system will start drainage automatically for 7 minutes. After testing the machine and
it is working properly. Then the machine can be operated normally.
WARNING! Do not dismantle the safety pressure decrease valve arbitrarily.
IMPORTANT! Do not switch the water input pipe when the steam generator is working.
110
1. Steam Controls
2. Bluetooth Controls
3. Light Controls
4. User Presents
5. Settings
6. Steam Temp +
7. Steam Time +
8. Drain Water
9. Steam Temp -
10. Steam Time -
11. Start Steam Production
12. Error Codes
13. Bluetooth Icon
14. Standby Button