Installation Guide

SteamSpa PHONE: [phone] FAX: [phone] http://steamspa.com [e-mail]
Page 22
INSTALLATION & USER GUIDE
4. STEAM FUNCTION
Select the steam interface shown in Figure 1 after power-on: Press to start the
steam function; The steam key is shown as Figure ; Press the again to stop
the steam Function.
Steam temperature setting: Set temperature by pressing the key of "temperature+" or
"temperature-". Steam time Settings: Set to 5-60 minutes of steaming in 5 minute steps
by pressing the “time+” or “time-” keys.
Save user information: Through the user interface shown in Figure 5; select the user
bar to be used by pressing or key, then save your temperature and timing by pressing
the button.
To select your setting: Through the user interface shown in Figure 5: Select the setting to be used
with the or key, and press to select the saved user setting.
Scheduled start-up setting: Select the function bar of "Working Mode" shown in
Figure 6 on the setting interface, press OK key to enter the interface shown in Fig
ure 7
to set relative parameters.
① Time setting: Stop the cursor on the desired “Timing” by using the or key, set
hours by pressing key, and minutes by key. The parameters are set in loop
with 1 hour increments and a range of 0-23 hours; And a 10 minute increments and a
range of 0-50 minutes.
② Working mode: Move the cursor from Sunday to Monday bar with key, Then
select the function options of: off, one-time schedule, or repeat schedule with
key. If the one-time schedule mode is selected, the system will change the
setting to “off ”automatically after one-time scheduled cycle is complete.
③ Save information by pressing key and run as per the set parameters. Exit the
set
ting interface by pressing the key.
④ When system is running under the scheduled start-up mode, the temperature and
steamer working time set by user1 shall be taken as default. For example, if the
temperature is 110℉ and the working time is 30 minutes set by user1, then the
temperature shall be 110℉and the working time shall be 30 minutes under the
scheduled start-up mode. If the working time is adjusted after start-up, the scheduled
shut off time shall subject to the final set time.