Full Product Manual

IMPORTANT SAFETY INSTRUCTIONS
6.Be certain that steam bath enclosures are
properly sealed to avoid water damage from
escaping steam. It's recommended that
100% silicone caulk be used to seal all pipes
and fittings. Steam must be prevented from
escaping into the wall cavity.
7.Never shut off the water to a steam gener-
ator that is in use.
8.We recommend choosing steamers which
are closely matched in power. The highest
kW steamer should be the primary unit. Each
steamer should have its own automatic drain.
9.An exhaust fan installed outside the steam
room is strongly recommended to remove
excess steam from the bathroom or shower
area.
10.For commercial use, we recommend
checking with your local inspectors to
confirm the system is acceptable for your
use. Many jurisdictions will require an ASME
boiler for commercial use: Steam Spa
generators are not boilers.
11.The steam outlet carries hot vapor! A separate
steam line is required for each steam outlet. Do
not connect a valve or shut-off in the steam line!
Avoid traps and valleys in the steam line where
water could collect and cause a steam blockage.
The hot steam line must be insulated against user
contact.
12.Do not install the steam head near a bench or
where steam may spray or where condensation will
drip on the user as this will present a scald hazard.
13.Centering the steam pipe is critical in rooms
made of plastic, acrylic, resin, fiberglass or similar
materials. Allowing the steam pipe to touch
materials not rated 240°F (115°c) or higher will
result in damage to these materials.
14.Wire the controls exactly as described. Do not
connect any additional wiring or power supplies to
the controls or their terminals in the generator.
15. SAVE THIS MANUAL.