Owners Manual
Table Of Contents
- Prologue
- User Instructions
- Choosing the Right Location
- Installation Drawing of Steam Generator
- Plumbing Installation
- Steam Generator Specifications
- Electrical Requirements
- Assembly Graph for Power Wire
- Installation of the Top light
- Steam generator DISSECTION DIAGRAM
- Care & Use for the control panel
- Controller Box Content
- Control Panel Installation instructions
- Testing the Machine
- Control Panel Diagram
- Steam Generator Maintenance
- Technical Parameters
Insulated copper wire should be used with an anti-heat temperature of 90 and a specified voltage of 300V. Refer to national
SteamSpa PHONE: 800-856-0172 FAX: 866-560-1060 http://steamspa.com info@steamspa.com
Page 13
INSTALLATION & USER GUIDE
ATTENTION! To facilitate maintenance, keep the steam engine clean. If the information provided is limited, do not operate on the
pipeline and electric equipment arbitrarily as shown in the figure for proportion.
ELECTRICAL REQUIREMENTS
ELECTRICAL SUPPLY CIRCUITRY
1. Test the voltage of the power supply and make sure suitable voltage is used for the steam generator.
2.
or local electricity consumption code for the specifications. Refer to the ammeter for the ampere.
3. Connect suitably sized equipment grounding wire into the ground terminal.
4. All the connections must be in accordance with national and local electricity consumption codes and be installed by
professional electricians.
10.5k W/12k W/15kW
535mm
435mm
Steam outlet
Safety valve
Water inlet
Water
dr ainage
Fuse for wire power supply
Power wir e hole
Contr oller wire and
light wire hole
35 0mm
38 5mm
234mm
273mm
183mm
34mm
Fuse for wire
power supply
℃