Instructions / Assembly

SteamSpa PHONE: [phone] FAX: [phone] http://steamspa.com [e-mail]
Page 9
INSTALLATION & USER GUIDE
ATTENTION! To facilitate maintenance, keep the steam engine clean. If the information provided is limited, do not operate on the
pipeline and electric equipment arbitrarily as shown in the figure for proportion.
ELECTRICAL REQUIREMENTS
ELECTRICAL SUPPLY CIRCUITRY
1. Test the voltage of the power supply and make sure suitable voltage is used for the steam generator.
2. Insulated copper wire should be used with an anti-heat temperature of 90 C and a specified voltage of 300V. Refer to national
or local electricity consumption code for the specifications. Refer to the ammeter for the ampere.
3. Connect suitably sized equipment grounding wire into the ground terminal.
4. All the connections must be in accordance with national and local electricity consumption codes and be installed by
professional electricians.
10.5kW/12kW/15kW
535mm
435mm
Steam outlet
Safety valve
Water inlet
Water
dr ainage
Fuse for wire power supply
Power wire hole
Controller wire and
light wire hole
35 0mm
38 5mm
234mm
273mm
183mm
34mm
Fuse for wire
power supply