Instructions / Assembly

SteamSpa PHONE: [phone] FAX: [phone] http://steamspa.com [e-mail]
Page 7
INSTALLATION & USER GUIDE
DRAINPIPE (1/2’’)
ACCORDING TO THE NATIONAL AND LOCAL PLUMBING CODES: The steam generator drain valve should be equipped with a
drainpipe. The steam generator drains the water by using gravity, and pitch is required. Check local code requirements for drain
valves. Do not connect the safety valve or steam line to drain line.
SAFETY VALVE (3/4’’)
1. Safety valve is an automatic system that is actuated by pressure in order to prevent steam pressure increasing in the interior
of the generator .
2. The pressure limit range of the safety valve is 15 PSI and the pressure will begin to decrease if pressure should come over this
value.
3. If it is allowed by local codes, provide the safety valve with exterior drainpipe.
4. Do not dismantle the pressure relief valve while generator is in operation..
5. To maintain the proper automatic operation of the safety valve, make sure the safety valve connection pipe is smooth.
Airproof green material belt
If non-heat-resistant material like
acrylic is used as building material,
reserve a gap no smaller than 1/4’’
and fill with heat-insulated material.
Use airproof silica gel or
corresponding airproof material to
fill the gaps in the wall to achieve the
water-proof and damp-proof effect.
Inside wall in the steam room