Full Product Manual

Figure 2: Configuration Diagram
Double pump
Single pump
1. Pump A
2. Pump A switch
3. Mounting plate
4. Aroma oil controller
5. Housing
6. Pump B switch
7. Pump B
8. Aroma oil container
9. Control line
10. Pump B inlet
11. Pump B outlet
12. Pump A inlet
13. Pump A outlet
14. Power line
15. Pneumatic switch interface
Installation
Notice: There are three control modes in steam aroma diffuser: Controlled by a steam engine with a control aroma output
(contact output); Controlled by an operating system consisting of pneumatic switch and temperature controlled switch;
Operated and controlled by its own buttons.
1. The steam aroma diffuser should be installed in a place where is convenient to observe, so as to monitor the consumption of
aroma oil, and add and replace it timely.
2. The aroma diffuser can only be fit for indoor use and must be installed in a dry and clean environment without moisture,
condensed water or high humidity.
3. The aroma diffuser should be installed in a vertical surface.
For single pump SS-SAP001-XX, two screws (ST5*20) with a horizontal distance of 200 mm shall be installed about 1.5m
above the ground, and then mount the aroma diffuser. Refer to the Figure 8;
For double pump SS-DAP001-XX, two screws (ST5*20) with a horizontal distance of 260 mm shall be installed about 1.5m
above the ground, and then mount the aroma diffuser. Refer to the Figure 9;
4. The aroma diffuser cannot be installed in a place where water can freeze, and cannot be installed outdoors.