Full Product Manual

5. The aroma diffuser should not be installed a place where is close to flammable materials, materials with corrosive

properties and chemicals.

6. The installation of aroma system should be easy to operate, and enough space should be left for maintenance and

injecting aroma oil.

7. The system should be installed in a place where is not easy for children to touch, and you'd better install it in a

special isolation room

8. The pump outlets on the aroma diffuser should be higher than aroma oil injection ports on the steam pipe, but

should not be higher than 1.5 meters.

Notice:

a. The aroma diffuser should not be installed in a place where is above or below the steam engine, because such

places are easily affected by heat.

b. The minimum distance between the steam engine and aroma diffuser should be 0.5 m, if not, please install a

thermal insulation board or thermal insulation materials between them.

c. The environment temperature should not be higher than 90°F, which is caused by the impropriety between aroma

oil and high temperature.

Install an aroma injection port on steam pipe:

1. Installation on 3/4" steam pipeline: Use the 3/4'' copper three-way valve for direct installation on the steam pipe.

2. Installation on 1/2" steam pipeline: Use the 3/4'' copper three-way valve and adapter for installation on the 1/2"

steam pipe.

3. Use the 3/4'' copper three-way valve with aroma oil injection port for installation on the place within 2.5m from the

steam jet. Please note that the aroma oil injection port should be vertical upward.

4. Polytetrafluoroethylene tape must be wound during installation to ensure the sealing.

Notes: In case that the heating mode of the system is not steam pipe, the users can voluntarily design the injection

port as per the aroma oil conveying hose.

Hose

Adapter

3/4" steam pipe

3/4" tee

1/2" steam pipe

Hose

Aroma injection port

Figure 3