Full Product Manual

Installation of aroma oil conveying hose:
Lead the other end of the aroma oil conveying hose on the aroma diffuser to the aroma injection port installed on the steam pipe,
and then plug it. Refer to figure 6 below.
Notice: In case of melting or damage, the silicone tubing should not be placed in ultra-high temperature area.
Installation of aroma pump system:
Notice: The aroma pump system is equipped with external cable plug and control cable. In case of any damage of the system
and cable, it must be replaced by the relevant service agencies or professional personnel. All wiring must be conducted by
licensed and qualified electricians.
Beam clamp (not provided)
Control line
Insulation mat (not provided)
Temperature controller
Figure 4
Installation of pneumatic switch button (only for single pump SS-SAP001-XX)
1. Open a ￠ 32 hole on the steam room wall with a height of
about 1.5m, which is easy to operate.
2. Install the pneumatic switch button as shown in Figure 4.
3. Connect the other end of hose to the pneumatic switch interface
on the aroma diffuser as shown in Figure 2 and Figure 7. It is
best to add a little glue to the hose and interface.
4. Notes: The gasket should be placed on the side of the button, and
the hose should be avoided jamming and touching high
temperature.
5. The installation steps of pneumatic switch button are only
available while using the operating system of aroma diffuser
consisting of pneumatic switch.
Steam pipe
Installation of temperature controlled switch:
1. Fix the temperature controlled switch in a proper position with a
beam clamp on the steam pipe (must be copper pipe) which is
convenient for installation. Refer to the Figure 5;
2. As shown in Figure 5, add insulation mat on the temperature
controlled switch firstly, and then fix the temperature controlled
switch in a steam pipe with a beam clamp.
3. Connect the two inserts of control line and control switch.
4. The temperature controlled switch is normally open for 90℃
(Normal Close) and only closed when there is steam passing
through the steam pipe.