OWNER’S MANUAL FOR STEARNS® INFLATABLE KAYAK YUKATAT™ (B523) IMPORTANT! BEFORE PROCEEDING READ THIS MANUAL CAREFULLY (CONTAINS IMPORTANT SAFETY INFORMATION, AS WELL AS CARE AND MAINTENANCE) Yukatat™ (B523) Stearns® Inc. St. Cloud, Minnesota 56302 U.S.A. Phone: (320) 252-1642 or 1-800-697-5801 Fax: (320) 252-4425 www.stearnsinc.
Note: If your state requires this document for licensing your boat, please contact Stearns® Customer Service Department for completion, or more information.
OWNER’S MANUAL FOR STEARNS® INFLATABLE KAYAK TABLE OF CONTENTS Declaration of Conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 2. Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 2.1 Modifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 3. Boating Safety . . . . . . . . . . . . . .
Declaration of Conformity (according to ISO/IEC Guide 22 and EN 45014) Manufacturer’s Name: Stearns Inc. Manufacturer’s Address: P. O. Box 1498 St.
1. INTRODUCTION This manual has been compiled to help you operate your craft with safety and pleasure. It contains details of the craft, the equipment supplied or fitted, its systems, and information on its operation and maintenance. Please read it carefully, and familiarize yourself with the craft before using it.
3. BOATING SAFETY This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury or substantial property damage. Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury or property damage.
3.1 Boating Regulations The U.S. Coast Guard is the authority of the waterways; they are there to help the boating public. State boating regulations are enforced by local authorities. You are subject to marine traffic laws and “Rules of the Road” for both federal and state waterways; you must stop if signaled to do so by enforcement officers. There are many pamphlets, prepared by the Coast Guard, available to you.
3.2 RESPONSIBILITIES OF THE OPERATOR(S) IMPORTANT Users of this product agree by their use to accept the inherent risks involved in this water sports activity and agree to follow all instructions, DANGERS, CAUTIONS, and WARNINGS carefully before using their STEARNS® kayaks. ● READ OWNER’S MANUAL: Improper Use May Cause Injury or Death. Pay close attention to items marked “DANGER,” “WARNING,” “CAUTION” or “NEVER.” ● Use the kayak in a SAFE and SOBER manner, taking all reasonable precautions.
4. SPECIFICATIONS Dimensions: Yukatat™ (B523) Length - 10’ 4” (315 cm) Beam - 33” (84 cm) Dry Weight: Max. Persons Capacity: 31 (14 kg) 1 person Max. Persons & Gear Capacity: Recommended Pressure: Main chambers: Floor chamber: 285 lbs (129 kg) 1.75 psi (0.12 bar) 1.0 psi (0.07 bar) 4.1 CAPACITY The person/load capacity is determined by the availability of proper seating on the kayak. Acceptable seating determines the number of passengers, not the overall load capacity.
4.2 FEATURES Yukatat™ 5 9 12 7 4 11 6 5 2 2 10 9 8 1 8 3 1 11 1. Main chamber valves 2. Carrying / grab handles 3. Floor valve 4. Knuckle abrasion guards 5. Tie down cords 6. Mesh pocket 10 4 7. Chamber access zippers 8. Bow and stern access zippers 9. Mesh pocket 10. Bow and stern rigid stems 11. Spray deck chambers 12. Seat 5. PREPARING YOUR STEARNS® INFLATABLE KAYAK The STEARNS® Inflatable Kayak is designed for recreational use and can be used in a number of settings.
5.1 QUICK START TO INFLATING YOUR KAYAK Follow the steps listed below. Damage to chambers can occur if these steps are not followed. For more information on inflation see page 11. 1. Unfold and lay out kayak on flat, level ground 2. Floor should be positioned inside Hull DO NOT OVER INFLATE FLOOR CHAMBER beyond 1.0 psi (0.07 bar) 3. First inflate the floor chamber until chamber feels semi-firm. DO NOT OVER INFLATE MAIN CHAMBERS beyond 1.75 psi (0.12 bar) 4.
5.2 KNOWING YOUR VALVES Yukatat™ kayak uses three types of valves. Type I (Type II, is a smaller version) to inflate floor and main chambers. Type IV is used to fill small chambers such as spray rings and spray deck lifters. Type I (II) Valve Cap To inflate . Welded Reciprocal . To deflate Type IV Twist to inflate/deflate 5.3 MAKE SURE: 1. Air chamber valves are centered with the inflation valve cover 2.
5.4 OVER INFLATION CAUTION Do not over-inflate the kayak. Over-inflation is the primary cause of leaks. Inflate the kayak until most of the wrinkles in the fabric are gone and it feels firm to the touch, but do not exceed 1.75 psi (0.12 bar) in the main air chambers and 1.0 psi (0.07 bar) in the floor chamber. Water temperature and weather affect the air pressure in the boat. In cold weather your kayak will lose some pressure because the air will contract.
6. UNDERWAY In all your uses of STEARNS® Inflatable Kayaks, make SAFETY a high priority. Each person should wear an approved personal flotation device. Learn about your boating area. Get official information about the local conditions, tides and currents before kayaking there. Be careful that you do not overestimate your strength, endurance or skill. Be careful never to underestimate the forces of nature. 6.1 Before You Start Be smart when kayaking and using your equipment. ● Properly inflate your kayak.
6.3 Care and Maintenance The STEARNS® inflatable kayak is made of very durable materials. However, like anything else, proper care will increase the life of your kayak. Before storing your kayak, make sure it is clean and completely dry before you store it in its carrying bag. It should be deflated and kept out of direct sunlight when stored. Avoid exposure to extreme temperatures (hot or cold). If your kayak is exposed to freezing temperatures while storing, allow it to warm before unfolding.
7. REPAIRS The STEARNS® Yukatat comes equipped with a repair kit that includes adhesive and several patches. This can be found in the mesh pocket and should remain with the boat. Making repairs to the inner tube of the boat may require unzipping the cover and temporarily removing the tube. Always make sure the boat is fully deflated before unzipping the cover. If there is difficulty opening the zipper, refer to the section “Care and Maintenance.
7.3 Seam Openings Seam openings are difficult to repair but can be done with certain seam repair adhesives. Contact STEARNS® for more information or ask your local marine shop. 8. TROUBLESHOOTING This chart will help you find and correct minor problems with your kayak. Problem Solution Slow leak. Check valve gaskets and make sure the cap tether is not interfering with the seal. The valve gaskets must be closed tightly. Still leaks slowly. Check for pinholes. Read section “Repairing Pinholes.
9. LIMITED WARRANTY STEARNS® warrants this product to be free from defects in material or workmanship for a period of one year from the date of purchase. Products that prove to be defective under conditions of normal and proper use during the warranty period because of defective workmanship or faulty material will be replaced or repaired without charge. For warranty service, return product to place of purchase.
STEARNS® WARRANTY REGISTRATION (PLEASE TYPE OR PRINT CLEARLY) Please complete and mail this card to Stearns within 10 days. It will register your product in case you ever lose your proof of purchase information. Owner’s Name _____________________________________________ Address __________________________________________________ City _________________ State_______ Zip________ Country_______ Model # ❑ Yukatat™ (B523) H.I.N.
NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES BUSINESS REPLY MAIL FIRST CLASS PERMIT NO. 558 ST. CLOUD, MINNESOTA POSTAGE WILL BE PAID BY ADDRESSEE STEARNS INC PO BOX 1498 ST.
