User manual

Notice
The display reacts slower at very low temperatures. In particular, this can apply for coolcept-
xdevices if they are used outdoors.
3.3.2 Information
The information shown on the display is described below using illustrative examples.
Status display
The status display shows the following values:
3
4
2
2
7 8
9
5 6
1
F
①
Measurement name
②
Measurement with units
③
Date is displayed alternatingly with IP address
④
Cover the Non-confirmed event messages; more information on this is provided in Section
Ä „Event messages“ on page 73
⑤
Animated symbol Connect symbol with 2‑digit inverter address; indicates data traffic on the
RS485 bus.
⑥
Cover the Power reduction (Derating)
⑦
Cover the Fixed voltage mode activated
⑧
Time
⑨
IP address of the device when a network connection has been established, display alternates
with ③ – ⑦
The following applies to the status display:
n The measurements shown in the status display are defined under Settings ▶ Meas. values.
Some measurements are always displayed (default setting).
n Current values are not displayed at night (solar irradiation too low; example in Fig. left).
n The CO2 saving shown in the status display are calculated using the savings factor
508 g/kWh .
EN
747.431 | Z09.3 | 2017-09-05 16