User manual

TCP/IP network

Notice

– A prerequisite for this is that you know the parameters required for setting up the

TCP/IP network connection. Consult (further) technical professionals if required.

– DHCP is activated in the device ex-works. This allows automatic integration of the

device in most networks.

Network settings, required for network communication, e. g. with an Internet portal:

n DHCP: Switch DHCP on/off

n IP address: IP address of the inverter

n Subnet mask: Subnet mask of the inverter

n Gateway: IP address of the network gateway

n DNS address: IP address of the DNS server

n web-portal: Settings at the web portal

– Web portal setting: Disabling of data transmission and selection of a web portal

– Re-transmission: Data in the inverter is transmitted a second time

– Connection check: Checks the internet connection and indicates the result

3.3.4 Service menu

The service menu items are described below. Some items are password protected; see

Further

information on page 56 (menu structure)

You can obtain the password from technical support; see

Chapter 11 „Contact“ on page 94.

NOTICE!

Risk of reduced yields. In the service menu, inverter and grid parameters can be changed.

The service menu must only be operated by a specialist, who ensures that the change does

not violate applicable regulations and standards!

747.431 | Z09.3 | 2017-09-05