User manual

2 General information
2.1 General safety instructions
n This document is part of the product.
n Install and use the device only after reading and understanding this document.
n Always perform the measures described in this document in the sequence specified.
n Keep this document in a safe place for the entire service life of the device. Pass the document
on to subsequent owners and operators of the device.
n The yield of the system can be reduced through improper operation
n If the housing is damaged, do not connect the device to the DC or AC lines
n If one of the following components is damaged, immediately take the device out of operation
and disconnect it from the mains grid and PV generators.:
– Device (not functioning, visible damage, smoke, penetration of liquid etc.)
– Lines
– PV generators
Do not switch the system on again before
– the device has been repaired by a dealer or the manufacturer,
– Damaged cables or PV generators have been repaired by a technical specialist.
n Never cover the device
n Do not open the casing: Risk of death. Invalidation of the guarantee.
n Factory labels and markings must never be altered, removed or rendered unreadable.
n Comply with the instructions of the respective manufacturer when you connect an external
component that is not described in this document (e.g. external data loggers). Components
that are incorrectly connected can damage the device.
Safety information on the device (coolcept Indoor)
①
Dangerous voltages can remain present on the components up to 10minutes after switching
off the DC circuit breaker and the line circuit breaker.
②
Read and follow the manual!
③
Serial number as a bar code and in plain text
EN
747.431 | Z09.3 | 2017-09-05 5